Proof
Real systems, real specifications, and the engineering decisions behind them. Every project here was designed in SolidWorks, approved by the customer before fabrication, and factory tested before it left Concord Township.
40"
Outfeed height from a waist-level load
Manufacturing / OEMs
Two flange sizes, one production cell, and a 40-inch outfeed height reached from a waist-level load. Step feeders are a category most parts-feeding companies do not build.
Read the case study
3 sizes
One feeder, every pin correct
Robotics & Automation
Three sizes of dual-pointed actuator pin, all the same diameter, each needing the tapered end leading. Standard orientation tooling could not tell the two ends apart.
Read the case study
< 80 dB
All five feeders running
Automotive · Robotics & Automation
Five feeders into one robotic assembly cell, on a single shared baseplate instead of five separate machines — and quieter than most single-bowl feeders.
Read the case study
33 PPM
Per system
Manufacturing / OEMs
Two systems on one proposal for the same customer: one where either end could lead, and one where the nose end had to lead every cycle — then escape left or right on command.
Read the case study